避免出現花膠
　　Avoid glue
　　沒有膠水的問題
　　No glue problem
　　壓力跟不上問題的發展
　　Pressure can't keep up with the development of the problem
　　中空玻璃上膠機分為自動雙組分上膠機和半自動雙組分上膠機，兩種設備的清洗方法基本相同。中空玻璃上膠機使用后必須清洗干凈。如果不及時清理，雙組份膠水會在膠管和上膠機上固化，影響以后的正常使用。
　　Hollow glass gluing machine is divided into automatic two-component gluing machine and semi-automatic two-component gluing machine. The cleaning methods of the two equipment are basically the same. The insulating glass gluing machine must be cleaned after use. If not cleaned in time, the two-component glue will solidify on the rubber tube and the gluer, which will affect the normal use in the future.
　　涂膠機的清洗按下次使用的間隔時間分為兩種清洗方式，一種是每天的清洗是每班結束后的清洗工作。還有一次徹底的清洗，主要是設備準備清空，在此使用到下次使用的時間間隔比較長。這兩種清潔方法不一樣。
　　The cleaning of the glue applicator can be divided into two cleaning methods according to the next use interval. One is that the cleaning every day is the cleaning work after each shift. There is also a thorough cleaning, mainly the equipment is ready to be emptied, and the time interval between this use and the next use is relatively long. The two cleaning methods are different.

　　轉變完成后,關閉乙烯輸送管和壓力開關,繼續輸出白膠,直到?jīng)]有釋放的黑色橡膠,然后關閉白色橡膠壓力開關,關閉白色橡膠輸送開關,完成后清潔完成轉變。
　　After the transformation, close the ethylene delivery pipe and pressure switch, continue to output white rubber until there is no released black rubber, then close the white rubber pressure switch, close the white rubber delivery switch, and clean the transformation after completion.
　　很長時間(超過15天),設備需要空:生產任務完成后,關閉后壓力開關和轉換開關,把膠槍和煤油清洗,去除管道輸送膠,使用空氣壓縮機的高壓空氣吹管道內的膠干凈。
　　For a long time (more than 15 days), the equipment needs to be empty: after the completion of the production task, turn off the pressure switch and transfer switch, clean the glue gun and kerosene, remove the pipe conveying glue, and use the high-pressure air of the air compressor to blow the glue in the pipe clean.
　　以上就是雙組份打膠機清洗流程的詳細介紹，想要了解更多請點擊官網http://linshi.jncsjx.com
　　The above is a detailed introduction to the cleaning process of the two-component dispenser. For more information, please click http://linshi.jncsjx.com