1.在涂膠過程中，中心中止時刻較長，或多次堆集，而且在上膠結束時無法完成清潔，特別是在夏日溫度較高時。

During the gluing process, the center stops for a long time or accumulates multiple times, and cleaning cannot be completed at the end of gluing, especially during high summer temperatures.

2. AB成分的氣壓缺乏，導致混合不均勻，凝膠緩慢，簡單發生顆粒

2. Lack of air pressure of AB component leads to uneven mixing, slow gel and simple particles

3. B組件未經檢查和清潔。 B成分對水蒸氣敏感。由于運送和儲存環境等偶爾因素，B組分的外表可能會結皮，外殼的一部分被壓入管道中，這很簡單發生顆粒。

3. Component B has not been inspected and cleaned. Component B is sensitive to water vapor. Due to occasional factors such as transportation and storage environment, the surface of component B may crust, and a part of the shell may be pressed into the pipeline, which can easily cause particles to occur.

4.過濾器和單向止回閥長時刻未清洗。

4. The filter and one-way check valve have not been cleaned for a long time.

5.B組件壓板上的O形圈，運用時刻長，松動。

The O-ring on the pressure plate of component B has a long service life and is loose.

丁基膠打膠機阻塞解決方案：

Solution for blockage of butyl adhesive applicator:

1、斷開膠水需求花費多長時刻，主張?jiān)跀嚅_(kāi)時刻之前，依據每天的溫度和濕度的不同，在每天施加膠水之前丈量剝離時刻。另外，目前的客戶常常要求膠水的固化時刻要快，中止時刻要長一些，而且簡單引起顆粒的呈現。

1. How long does it take to disconnect the adhesive? It is recommended to measure the peeling time before applying the adhesive every day based on the temperature and humidity difference before the disconnection time. In addition, current customers often require the curing time of adhesive to be fast, the stopping time to be longer, and it can easily cause the appearance of particles.

2、簡單的處理辦法是運用刮刀清潔外殼，而不影響膠水的運用。

2. The simple solution is to use a scraper to clean the outer shell without affecting the application of glue.

3、主張定期清潔過濾器，單向止回閥，靜態混合器和膠槍。

3. Advocate regular cleaning of filters, one-way check valves, static mixers, and glue guns.